Whynter T-1 Instruction Manual download pdf (Page 8)

5. Operations

Temperature Setting

It is recommended that you install the wine cooler in a place where the ambient temperature is

between (60- 80°F). If the ambient temperature is above or below recommended temperatures,

the performance of the unit may be affected. For example, placing in extreme cold or hot

conditions may cause interior temperature to fluctuate thus the set temperature may not be

achievable.

You can set the wine cooler temperature by pressing the “ ” and “ ” buttons on the control

panel.

Temperature settings for upper zone: 44ºF-66ºF (Left side control panel)

Temperature settings for lower zone: 50ºF-66ºF (Right side control panel)

Generally for red wines, the temperature range should be between 57ºF – 61ºF and for white

wines, the temperature range should be 50ºF - 54ºF. This is based on an ambient room

temperature of 77ºF.

Interior Light

You can turn on and off the interior light by pressing the “Light” button. The “Light” button on the

left side controls the upper zone light and the “Light” button on the right side controls the lower

zone light.

Handle Bars

Your wine cooler comes with a towel bar style handle. To install the handle, you will need a

Phillips-head screwdriver.

 Open the door of the wine cooler.

 Located the two screw holes on the inside of the door (they may be partially obscured by

the door seal so you may need to remove the door seal)

 Insert the screws into the screw holes until they stick out of the front of the door.

 Line up the holes in the handle with the screws and give each screw about 2-4 full turns

into the handle bar.

 Now the turn the screws in all the way, and your handles are installed.

 Replace seal into door frame.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Whynter T-1 Instruction Manual Page 8