Whynter CUF-210SS Instruction Manual download pdf (Page 7)

adequate ventilation and access for service. Never install or operate the unit in an enclosed area, such

as a closed cabinet.

 Before connecting the upright freezer to the power source, let it stand upright for approximately

4 hours. This will reduce the possibility of a malfunction in the cooling system from handling

during transportation.

 To ensure proper service access and ventilation, allow at least 4” clearance at rear, and 1” at

top and sides. The installation should allow the upright freezer to be pulled forward for servicing

if necessary.

 When installing the upright freezer under a counter, follow the recommended spacing

dimensions shown.

 This unit MUST be installed in an area protected from the elements, e.g., wind, rain, water

spray or drips. Do NOT use the upright freezer in outdoor setting.

 The upright freezer should not be located next to ovens, grills or other high heat resources.

 Too much humidity in the air will cause frost to form quickly on the evaporator requiring more

frequent defrosting of the upright freezer.

• The upright freezer must be installed with all electrical requirements followed.

• The unit should be located on a hard and level surface that can support the unit when it is full. It

is important for the upright freezer to be level in order to work properly. If needed, you can

adjust the height of the upright freezer by turning the feet. See the “Leveling the Upright

Freezer” section.

• A standard electrical supply (115 VAC only, 60 Hz, 10A), properly grounded in accordance with

National Electrical Code and local codes and ordinances is required.

• IMPORTANT: Do not kink or pinch the power supply cord between the upright freezer and wall

or cabinet.

Leveling the upright freeze

It is important for the upright freezer to be leveled in order to work

properly. It can be raised or lowered by turning the two feet on the bottom

of the machine. If the upright freezer is not leveled during installation. The

doors may not close or seal properly, causing cooling, frost, or moisture

problems. It is very important that the upright freezer is at level in order to

function properly.

Note: The leveling foot under the door hinge is smaller than the other

leveling foot.

We recommend using a carpenter’s level to check the machine.

1. Place a carpenter’s level on top of the product to see if the upright

freezer is level from front to back and side to side.

2. Adjust the height of the feet as follows:

• Turn the leveling feet to the right to lower that side of the upright

freezer

• Turn the leveling feet to the left to raise that side of the upright

freezer.

Reversing the Door Swing

Tools needed: Flathead screwdriver, Phillips screwdriver

Note: To avoid injury to yourself and property, we recommend someone assist you during the door

reversal process

This appliance has the capability of the door opening from either the left or right side. Please ensure the

appliance is unplugged and empty. Please follow the following instructions:

To take the door off, it is necessary to tilt the appliance backward. You should rest the appliance on

something solid (e.g. chair) just below the top panel so you can access the bottom of the upright freezer.

DO NOT lay the appliance completely flat as this may damage the coolant system.

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Whynter CUF-210SS Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Freezers Whynter CUF-210SS