Whynter CHC-251S Instruction Manual download pdf (Page 9)

Installation

INSTALLATION OF YOUR APPLIANCE

 The appliance is designed for a free standing installation.

 WARNING: Do not store or install the appliance outdoors.

 CAUTION: This appliance is designed for designed to storing and aging cigars . Do not store perishable

food, medicine or other medical products.

 Place your appliance on a hard and level floor that is strong enough to support it when it is fully loaded.

 To level your appliance, adjust the leveling legs at the bottom of the appliance if needed.

 When positioning the appliance, ensure that there is at least a 4” clearance at the sides and a 6” clearance

at the back. This will allow for adequate ventilation of any heat generated by appliance.

 We do not recommend installing the appliance on carpet.

 Do not install the appliance near an oven or other heating source. Direct sunlight may affect the acrylic

coating and heat sources may increase electrical consumption. For best performance, do not install the

appliance behind a cabinet door or block the base grille. Extreme cold ambient temperatures may also

cause the appliance not to perform properly.

 Avoid locating the appliance in area that may be exposed to excessive moisture.

 Plug in the appliance into an exclusive, grounded wall power outlet. Do not under any circumstances cut or

remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding

should be directed toward a qualified electrician or an authorized service center.

ELECTRICAL CONNECTION

This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground outlet with three-prong.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly

grounded. The cord should be secured behind the appliance and not left exposed or dangling to prevent

accidental injury.

The appliance should always be plugged into its own individual electrical outlet which has a voltage rating

that matches the rating label on the appliance. This provides the best performance and also prevent over-

loading house wiring circuits that could cause a fire hazard from overheated. Never unplug the appliance

by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle. Repair or

replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord

that shows cracks or abrasion damage along its length or at either end. When moving the appliance, be

careful not to damage the power cord.

EXTENSION CORD

Because of potential safety hazards, it is strongly recommended that you do not use an extension cord

with this appliance. However, if you must use an extension cord, it is absolutely necessary that it be a

UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding type plug and outlet

and that the electrical rating of the cord be 115 volts and at least 10 amperes.

WARNING: Improper use of the grounded plug can result in the risk of electrical shock.

If the power cord is damaged, have it replaced by a qualified electrician or contact

Whynter Service Department.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Whynter CHC-251S Instruction Manual Page 9